Product Description
Oil Injection Pump Re-Seal Kit
This kit will Reseal 100%of the Yamaha Worm gear style Oil Injection Pumps.
(OIL PUMP NOT INCLUDED)
Includes:
- Three internal pump seals, Large and small
- Engine side cover seal
- Pump to side cover mating gasket and body gasket
- Two Small shaft seals included for multiple applications
- New Hardware.
- Kit does not include a new end plug if your pump does not have the thumb wheel. (HVC200103-2)
Product Videos
Custom Field
Product Reviews
26 Reviews Hide Reviews Show Reviews
-
Autolube pump rebuild kit
Everything you need to rebuild these old Yamaha oil injection pumps. Nice to have a complete kit available, as a couple of the seals were not shown as available on the Yamaha parts schematic for my LTMX.
-
Yamaha Oil Injection Reseal Kit
Looks like a good kit. Decided to send my pump in for a rebuild since it is 47 years old and I don't want it to fail. Also putting a spark plug thermocouple temp gage on bike to make sure I am getting oil. Keeping this kit for the future
-
Excellent kit for old pumps
Has everything to rebuilt the pump.Thanks!
-
oil pump kit
excellent kit, all parts included great value and excellent cost. Very satisfied!!
-
Nice Kit
Just reassembled the pump today. All parts fit perfectly. Nice to be able to get all seals and gaskets in one kit.
-
Autolube Rebuild
Great quality.
-
Great kit for restorers
Haven't used the kit yet, but it's great know that everything I need to rebuild my Yamalube pump is all in one kit. No more sourcing out each part.
-
Awesome!
Every thing I needed to rebuild my Pump! Thanks! I did Think shipping was to much! $12 for such a small Item!
-
Caution
When you disassemble your pump,the gear inside that runs off the worm drive gear has in it some tricky parts. Take it apart slowly. The gear has a large thin washer over the gear, On the shaft the gear sits on, there are two, tiny spring loaded pins. Leave the gear on the shaft! If you remove it, the pins will pop out. If you're not working in a plastic bag, bye-bye pins. (Found out the hard way!) The pins are not available as far as I or HVC is aware of. In my case, bought a scrap pump only for the pins. Putting this all back together is a bear. I used a rubber band to hold the pins in place and then slid the gear back on the shaft.